MAJOR CAUSES FOR END BREAKS IN SPINNING

Reasons for end breaks at starting SPINNING END BREAKS AT STARTING

Following are the some points for higher breakage rate in cop bottom stage:

1. Improper selection of ring Travellers, e.g., Traveller weight, height and cross section

2. Improper setting of lappet height and abc ring height

3. The spindle speed grasp is not properly set

4. Variation in ring & spindle centering

5. Improper selection of TM in the count

6. Improper selection of spacer & top arm pressure

7. Cop build at bottom is not properly setting

8. Worn-out separators

9. Chase length is not properly set as per ring diameter

10. The diameter of bobbin should be always min 2.5 MM lesser than ring diameter

11. Improper selection of ring diameter vs. lift & count spun

12. Improper humidity and temperature.

SPINNING END BREAKS AT STARTING

With the above points, we can reduce breakage at cop bottom stage.